Evaluate Wireframe Dialog An explanation of fields and properties

To access this dialog:

• Run the evaluate-wireframe command.

This dialog is used to select a wireframe object and associated type and options settings when evaluating the displayed drillholes or block models, above or below a DTM or within a wireframe, to generate average grades and tonnes, saved to a results file.

Field Details:

Wireframe Object: the name of the currently selected wireframe object. You can use the Pick button (to the right of the object name field) to select a wireframe interactively (in this situation, your current wireframe selection options - as defined by the Wireframe tab of the Project Settings dialog - will be temporarily disabled, and a 'select by object' mode enforced. Your original wireframe selection settings will be restored after object selection).

Type: specify if the wireframe you wish to evaluate is a DTM or if it is a Closed Volume. Note the same wireframe files can contain more than one closed wireframe model and more than one DTM. Evaluations in this case should be done by specifying a wireframe filter.

Option: If evaluating above the DTM (Volume Above DTM) the To field represents the maximum value in Z across which an evaluation will be performed. If evaluating below the DTM (Volume Below DTM) the To field represents the lowest Z value to include in the evaluation. These options are only available if the DTM option was selected (see above).

 

Clicking OK in this dialog displays the Mining Block Identifier dialog.